Traktor one button looper

[DJAdeSands]

What bit doesn't work?

[Stewe]

Here is quick tutorial, be sure to assign loop controls to a deck.

Add In > Modifier > Modifier 1 / if: M=0, than: M=1



Add In > Modifier > Modifier 1 / if: M=1, than: M=2



Add In > Modifier > Modifier 1 / if: M=2, than: M=0



Add In > Deck Common > Loop > Loop In/Set Cue / if: M=0, Trigger



Add In > Deck Common > Loop > Loop Out / if M=1, Trigger



Add In > Deck Common > Loop > Loop Active On / if: M=2, then: direct=0



I'll upload the mapping in a bit.

[shroombeats]

What bit doesn't work?

It just set Loop In again and again each press.

[shroombeats]

Here is quick tutorial, be sure to assign loop controls to a deck.

Add In > Modifier > Modifier 1 / if: M=0, than: M=1



Add In > Modifier > Modifier 1 / if: M=1, than: M=2



Add In > Modifier > Modifier 1 / if: M=2, than: M=0



Add In > Deck Common > Loop > Loop In/Set Cue / if: M=0, Trigger



Add In > Deck Common > Loop > Loop Out / if M=1, Trigger



Add In > Deck Common > Loop > Loop Active On / if: M=2, then: direct=0



I'll upload the mapping in a bit.

Cool! I'll try this out later. Btw, this should be mappable to any button right? Cause I noticed you guys just use the L key for your examples.

[Stewe]

Cool! I'll try this out later. Btw, this should be mappable to any button right? Cause I noticed you guys just use the L key for your examples.

It's L only because of the looping. You can remap this TSI to any other key that you want

one button loop.zip

[shroombeats]

great! works now. thank you both for helping

[shroombeats]

on a somewhat unrelated note, is there a way to clear Loop In? for example I accidentally set a Loop In and I wanna clear it.

[Stewe]

So the second button press should track a "button tap" and "button hold" hold actions. This way you can choose if you want to proceed to adding the loop out point by tapping a key or you can hold it down for a second and then reset the sequence (modifiers=0) up on release of the key.

I'll try to add this and then upload it to MAPS.

[shroombeats]

So the second button press should track a "button tap" and "button hold" hold actions. This way you can choose if you want to proceed to adding the loop out point by tapping a key or you can hold it down for a second and then reset the sequence (modifiers=0) up on release of the key.

I'll try to add this and then upload it to MAPS.

that'd be cool if possible! really appreciate the help and learning a whole lot here.