that's a good starting point... haven't tried this yet, but i'll try and let you know
that's a good starting point... haven't tried this yet, but i'll try and let you know
one button on the VCI-100 (the one in the center of the browser section) is different. the button is A#6 and the LED is B6. the rest are all the same AFAIK.
You mean like a tool?
Can you post a link i cant find it on the behringer homepage...
unfortunately not a tool - only a pdf sheet with all the numbers
http://www.behringerdownload.de/DDM4...0-19_Rev.0.pdf
© 2008 | djDexter
Sorry for my bad english
had a crack at mapping the vci 300 and got some results, thought I'd share, vu meter leds tend to cause a lot of crackle, which i managed to reduce via raising the latency, some of the leds assigned dont seem to work if when their counter part is assigned, i.e i assigned the sync buttons as a test but only one works if the other is mapped to an led, looks like progress is slow, and hampered by these little setbacks, anyone tried this?
1x Allen & Heath Xone K2, 1xXone K1, Edirol PCR M1, 4x Numark TTXUSB, Audio10 and a truck load of vinyl...
"Send midi clock" will remove clackle. I see date of posts, thx for diagram btw.
Q6600/8GB/E-MU 1820m/KRK RP5+RP10s
MacBook/8GB/VCI-300
|
Bookmarks