Can you be a little more specific?It seems to come on for a number of button compressions then go off.
-To have a LED light only when held set: (like for a modifier button)
Map the button to the control you want to light up only when held.
1.Highlight the Control and click Duplicate
2.Change the Interaction Mode to Output
3.Change the assigned MIDI key in the pull-down menu next to Learn. The numbers start with CC. Use the manual and my cheat-sheet to find the corresponding number
4. then set the following:
Controller Range Min = 1 Max = 7
Midi-range Min = 127 Max = 63
Check Invert
-To have a Led light blink with the beat:
1.Click "Add"
2.Select "Output"
3.Click on Beat Phase Monitor
4.Assign the deck
5.Select the corresponding CC
-As for the scratch issue, in my opinion, it must be how TP works, cause I've tried about every combination I can think of. When the 'SCRATCH' button is pressed the deck stops, then resumes after scratching. Anyways, the "JOG" wheel on the BCD3000 is just an endless potentiometer, not the best for scratching.
Bookmarks